Publicité
Play mode
HR-GP5
HR-RC5
Recalling Effects From
Memory
Recall the desired effect.
Using the HR-GP5 main unit:
Turn the operation dial or use the shuttle
ring to select the desired memory number
(PI -PI
00
,
U1-U100*). □
ITie selected effect is recalled from memory.
If ENTER LOAD has been selected with the
system mode's setup function (see page 54),
press the FUNCTION F button after
selecting the memory number.
* U001 ~U100 are user memory numbers.
Only those numbers which contain
effects can be selected. (See page 48)
Using the dedicated HR-RC5
remote controller: 0
Check to make sure the MANUAL lamp is
extinguished, then press the 1/A-5/E
pedal. When the pedal is pressed, the
lst~5th number of the bank is selected and
displayed in the window.
* A bank is
a
group of five programs. To
move to the next higher bank, press the
BANK UP/F pedal. To move to the next
lower bank, press the 3/C pedal while
holdingdovvn the BANK IJP/F pedal.
Memory number display 0
Effects are stored in the preset memory
numbers 1-100 at the factory. When the
operation dial (or shuttle ring) is turned,
the memory numbers are sequentially
displayed in an endless cycle. If original
effects have been stored in the user memory
area, the valid user memory numbers are
inserted after the preset memory numbers
in the memory number sequence.
a) When shipped from the factory
b) When effects are stored in user memory
c) User memory
26
Publicité
