Publicité
input level.
Adjust so that the signal lamp does not
light red. This adjustment affects the
quality of the elTect. To obtain a proper
eflect, never use this control tor other
purpose such as to adjust the output
volume.
Input level and signal lamp
relationship
Signal lamp indicator
Input level
Lights red continuously
Too high
Lights red occasionally
Correct
Lights green or orange
Only lights green
Too low
3
Turn the operation dial or use the
shuttle ring to select the desired
memory number (P1-P100,
U1-U100*).
*U1~U100 are user memory numbers.
Only those numbers which contain an
effect can be selected. (See page 48)
Before turning on the power of
connected components
Set the volume lev els ot the connected
components to a low level to avoid
unintentionally outputting a large sound.
To directly output the input
signal (Bypass) 0
Press the bypass button. The input signal is
output directly without being processed by
the effect circuitry. Press again to cancel the
bypass mode.
When using the dedicated HR-RCfi remote
controller (optional), press the controller's
BYPASS switch. Press again to cancel the
bypass mode.
18
Publicité
