Télécharger Imprimer la page

Frecan POMEROL 88 BC Manuel D'instructions page 9

Publicité

service centre.
The appliance must be installed to all electrical,
plumbing,
water
accordance with state and local codes.
IMPORTANT: HIGH HUMIDITY CLIMATE. During
periods of high humidity, some condensation may
appear on outside surface of glass door. This
condensation will disappear when humidity levels
drop. For prevention, it is advisable to install the
appliance with sufficient ventilation in a dry and/or
an air-conditioned place or switch on the ANTI-
CONDENSATION MODE if available.
NOTE: The appliance must be positioned so
that the plug is accessible.
BUILT-UNDER INSTRUCTIONS
Make sure your installation does not block the front
ventilation grille. The unit is designed to fit under
worktops between 820 and 890mm in height, using the
height-adjustable ventilation grille to ensure that the
feet are concealed from front view. Remove the
adjustable ventilation grille screws and slide it to the
required height. Tighten the screws to lock the grille in
position.
If the unit is fully integrated to be installed for fitting
kitchen plinth, make sure that the ventilation gaps in
the plinth are at least 300 square centimeters and
remove the ventilation grilles, so that warm air can
disperse unhindered. Otherwise the appliance has to
work harder, resulting in an increase in electricity
consumption.
NOTE: When pushing the appliance into the niche,
make sure that the mains cable does not get trapped.
A
(mm)
15cm
148
150
Wide
30cm
295
300
Wide
Code Rev. E 20240815 (IEC)
and
drain
connections
B
C
D
(mm)
(mm)
(mm)
440
105
440
115
/460
40cm
395
Wide
50cm
495
in
Wide
60cm
595
Wide
NOTE:
H – Can be 700, 720, 780 or 800mm and it depends on
the actual product specification.
h – Can be 80, 100, 120 or 150mm and it depends on
the
actual
product
maximum adjustable height for plinth is 70mm. If you
need the more adjustable height legs, they can be
purchased from your dealer or from the Spare Parts
Department.
For flush inset built-in installation, an extra 3mm door
clearance is required for dimension B.
A (mm)
37.5cm
Wide
44.5cm
Wide
60cm
Wide
75cm
Wide
7
400
440
/460
500
440
/460
600
440
/460
specification.
B (mm)
C (mm)
375
380
495
445
450
520
595
610
520
750
760
520
115
115
115
The
standard

Publicité

loading