Publicité
DESIGN 2 –
1.
Remove the door gasket (2) on the side you wish
to install the handle - you can see two designated
holes for handle installation.
2.
Install the handle (4) tightly as shown above with
two screws (1) and flat washers (3) provided.
3.
Replace the door gasket.
DESIGN 3 –
1
2
Locate the handle (2) on the door and secure the
handle with two supplied screws (1).
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
Note: All parts removed must be saved to
do the reinstallation of door.
DESIGN 1 – For built-under models
1
1
6
8
1
1.
Unscrew the lock screw (1) then gently lift and
slide the door outward the right to release it. Be
Code Rev. E 20240815 (IEC)
2
3
2
3
4
5
5
4
6
7
careful to hold the door firmly after removing the
screw. (Fig. 1)
2.
Gently pull down to remove the door from the
right top hinge and place it on a padded surface
to avoid the risk of damage. Transfer the door pin
(2) to the opposite of door. (Fig. 2)
3.
Remove the right bottom hinge (4) and the right
top hinge (7). (Fig. 2 & 5)
4.
Pop out the cover caps on the left side of cabinet
and use them to
right side.
5.
Unscrew and transfer the holes cover (6) and
lock catch (5) to the opposite side of glass door.
(Only for models with lock on the ventilation grille)
(Fig. 3 & 4)
6.
Screw the alternative left top hinge, included in
the fittings,
on the left side of cabinet.
7.
Screw the alternative left bottom hinge (8),
included in the fittings,
8.
Rotate the door 180° and relocate the door to the
designated position. Lift and slide the door
inward from the left and secure the door pin (2)
with lock screw (1). (Fig. 6)
9.
Recheck and adjust the door alignment by
loosening the lock screw (1) and moving the door.
Tighten the screw (1) after the door is levelled.
(Fig. 6)
DESIGN 2 – For fully integrated models
1.
Remove the glass door by unscrewing the eight
lock screws (3) and (4). Be careful to hold the
glass door firmly after removing the screws and
place it on a padded surface to avoid the risk of
damage.
2.
Unscrew and transfer the door supporter (2) to the
opposite side.
3.
Rotate the glass door 180°and refit the glass door
to the opposite side. Then screw and tighten it
after the door is leveled.
10
cover the screw holes on the
on the left side of cabinet.
Publicité
