Publicité
When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults. The preset temperature at the factory for
UPPER/LEFT temperature zone is 8ºC (46ºF) and
for LOWER/RIGHT temperature zone is 12ºC
(54ºF).
You can touch the left side UP and DOWN keys to
control
the
internal
UPPER/LEFT temperature zone and touch the
right side UP and DOWN keys to control the
internal
temperature
temperature zone. When you touch either key at
the first time, the display will show the last
temperature set previously.
IMPORTANT: For non-Twin Wine Conditioning
System, the temperature set for the LOWER
temperature zone must always be just as high as
or higher than that in the UPPER temperature
zone.
The temperature that you desire to set will
increase 1ºC or 1ºF if you touch the UP key once,
on the contrary the temperature will decrease 1ºC
or 1ºF if you touch the DOWN key once. The
display flashes while you make the setting.
After the temperature has been set, the display
shows the current inner temperature of the
particular temperature zone.
To view the set temperature at any time, touch the
UP or DOWN key, the set temperature will
temporarily flash in the display for 5 seconds.
Then the display
temperature again.
USE AND CONTROL – DUAL ZONE with LCD
DISPLAY
The Controls of Your Unit
POWER
To turn the appliance off, lightly touch and hold the
key for 5 seconds until temperature display goes out.
To turn the appliance on, lightly touch and hold the
key for 1 second until temperature display lights up.
ºF/ºC Selector
Set the temperature to be displayed in degree
Fahrenheit or degree Celsius.
LIGHT
To turn the interior light on/off, lightly touch and hold
the
key for 5 seconds.
UP
To increase (warm) the set temperature by 1°C or 1ºF.
Code Rev. E 20240815 (IEC)
temperature
of
of
the
LOWER/RIGHT
shows
the current
inner
DOWN
To decrease (cool) the set temperature by 1°C or 1ºF.
Setting Selector
Select the temperature and humidity you want to set.
Symbols in the Display
Temperature or Error code display for
the
upper/left zone
Temperature or Error code display for
lower/right zone
Compressor is ON.
Heater is ON.
Defrosting mode.
DynaClima mode.
Eco Demo mode.
The interior light is in Showcase mode.
Warning
Audible tones signal
Child lock is activated
Wifi connection signal
Anti-condensation mode
Relative humidity display
Multi-key Function
To perform the multi-key function, lightly touch and
hold the first key, then touch the rest key for at least
5 seconds and then release all the keys.
Child Lock
If in 2 minutes or longer without touching any key, the
child lock will be activated automatically for models
with the control outside of cabinet. To cancel the lock,
lightly touch the UP and DOWN keys
for at least 5 seconds until the symbol
Setting the Temperature Control
The unit has two separate temperature zones. The
temperature of both zones can be set between
5ºC and 20ºC (41ºF and 68ºF). It can be used as a
wine maturing cabinet or a wine serving cabinet.
For maturing wine, the recommended temperature
setting ranges of both zones should be between
11ºC and 14ºC (52ºF and 57ºF). For serving wine,
the recommended temperature setting range of
UPPER/LEFT zone should be between 5ºC and
10ºC (41ºF and 50ºF) which is ideal for serving
champagne & white wine and the recommended
temperature setting range of LOWER/RIGHT zone
should be between 15ºC and 20ºC (58ºF and 68ºF)
which is ideal for serving red wine.
When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults. The preset temperature at the factory for
UPPER/LEFT temperature zone is 8ºC (46ºF) and
for LOWER/RIGHT temperature zone is 12ºC
(54ºF).
Touch
the
temperature you want to set is flashing. Then you
can use the UP and DOWN keys to set the
internal temperature as required. When you touch
either key at the first time, the display will show the
last temperature set previously.
16
simultaneously
is go out.
Setting
Selector
until
the
Publicité
