Publicité
Remove the shelf in front of the filter.
Grip the filter and turn it 90°clockwise or anti-
clockwise to remove.
Insert the new filter in the vertical position and turn
it 90° clockwise or anti-clockwise until it clicks into
position.
DOOR LOCK
If the unit is provided with a lock system, the keys are
located inside the plastic bag that contains the Owner's
Manual. Insert the key into the lock, push in and turn it
counterclockwise to unlock the door. To lock the door
do the reverse operation making sure metal pin is
engaged completely. Remove the key and place it in a
secure place for safekeeping.
CLEANING YOUR APPLIANCE
Turn off the power, unplug the appliance, and remove
all items including shelves and rack.
Wash the inside surfaces with a warm water and
baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
Wash the shelves with a mild detergent solution.
Wring excess water out of the sponge or cloth when
cleaning any area of the controls.
The sealing gasket around the door must be cleaned
regularly to prevent discolouration and prolong service
life. Use clean water. After cleaning the sealing gasket,
check that it continues to provide a tight seal.
Wash the outside cabinet with warm water and mild
liquid detergent. Rinse well and wipe dry with a clean
soft cloth.
Do not clean the stainless steel with steel wool
pads. We suggest using an all-in-one stainless steel
cleaner to clean the stainless steel. Always clean in the
direction of the grain.
POWER FAILURE
In the event of a power interruption, all previous
temperature settings are automatically memorized. If
power is interrupted (power surge, breaker switch, etc.)
and then powered up again, the unit will operate with
the last temperature set-point.
Most power failures are corrected within a few hours
Code Rev. E 20240815 (IEC)
and should not affect the temperature of your
appliance if you minimize the number of times the door
is opened. If the power is going to be off for a longer
period of time, you need to take the proper steps to
protect your contents.
NOTE: Irrespective of the cause, if you notice either
abnormal temperature or humidity levels inside your
unit, be reassured that only long and frequent
exposure to these abnormal conditions can cause a
detrimental effect on your wines.
VACATION TIME
Short holidays: Leave the unit in operation for
holidays of less than three weeks.
Long absences: If the appliance will not be used for
several months, remove all items, turn off the
appliance and unplug. Clean and dry the interior
thoroughly. To prevent odor and mold growth, leave
the door open slightly, blocking it open if necessary.
MOVING YOUR APPLIANCE
Unplug the power plug from the electrical outlet.
Remove the contents from the racks and all moving
parts from inside.
Raise the adjustable legs up to the base to avoid
damage.
Tape the door shut and lock it if with a lock system.
Transport the unit only in the upright position. Also
protect the outside of the appliance with a blanket or
similar item.
ENERGY SAVING TIPS
Should the unit be left empty for long periods of time, it
is suggested that the appliance is unplugged, and after
careful cleaning, leave the door ajar to allow air to
circulate inside the cabinet in order to avoid possible
condensation, mold or odors forming.
The appliance should be installed in the coolest area of
the room, away from heat producing appliances, and
out of the direct sunlight.
Ensure that the unit is adequately ventilated. Never
cover air vents. Clean dust and dirt from the condenser
at regular intervals.
Only open the door for as long as necessary and for as
short a time as possible.
Store the content in an organized way.
To allow air to circulate, do not overfill the appliance.
25
Publicité
