Publicité
IMPORTANT: For non-Twin Wine Conditioning
System, the temperature set for the LOWER
temperature zone must always be just as high as
or higher than that in the UPPER temperature
zone.
The temperature will increase 1°C/1ºF if you touch
the UP key once, or the temperature will decrease
1°C/1ºF if you touch the DOWN key once. The
display flashes while you make the setting.
The set temperature will temporarily flash in the
display for 5 seconds after the temperature has
been set. Then the display shows the current inner
temperature again.
To view the set temperature at any time, touch the
Setting Selector
temporarily flash in the display for 5 seconds.
Then the display shows the current
temperature again.
Setting the Humidity Control
Humidity level can be kept automatically for
models with humidity pump.
Touch the Setting Selector
display
is flashing. Now you can use the UP and
DOWN key to choose the relative humidity setting
from 50% to 80% and 00%. The set humidity will
temporarily flash in the display for 5 seconds.
Then the display shows the current inner humidity
again. The humidity preset at the factory is 70%
(ideal wine storage humidity).
When 00% is selected, the humidity pump will be
switched off. The humidity pump increases the
energy consumption of the unit. If the function is
not necessary, please switch it off. The rated
energy consumption is based on the function is
switched off.
Code Rev. E 20240815 (IEC)
key, the set temperature will
until the humidity
USE AND CONTROL – THREE ZONE with
LED DISPLAY
The Controls of Your Unit
Upper Control Unit
Lower Control Unit
inner
The appliance has two control and operating units. The
upper control unit controls the upper and middle
compartment. The lower control unit controls the lower
compartment.
POWER
To turn the appliance off, lightly touch and hold the
key for 5 seconds until temperature display goes out.
To turn the appliance on, lightly touch and hold the
key for 1 second until temperature display lights up.
The power of two control units can be turned on and off
separately.
LIGHT
To turn the interior light on/off, lightly touch and hold
the
key for 5 seconds. The interior light indicator will
light up or go out to confirm the selection.
The light of two control units can be turned on and off
separately.
UP
Used to increase (warm) the set temperature by 1°C or
1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C or
1ºF.
Display
Display the digital temperature and service indicators.
Light Indicator / Multi-key Function
The interior light indicator is the dot at the bottom right
of the display. The interior light indicator will light up in
showcase mode.
The interior light indicator will flash when the multi-key
function is selected. To perform the multi-key function,
lightly touch and hold the first key, then touch the rest
key for at least 5 seconds and then release all the keys.
Setting the Temperature Control
The unit has three independent temperature zones.
The temperature of all zones can be set between
5ºC and 20ºC (41ºF and 68ºF). It can be used as a
wine maturing cabinet or a wine serving cabinet.
For maturing wine, the recommended temperature
17
Publicité
