Publicité
PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling customer service.
TROUBLESHOOTING GUIDE
PROBLEM
Nothing works.
Appliance does not
operate.
Appliance is not
cold enough.
Appliance turns
itself on and off
frequently.
The light does not
come on.
Door will not open.
Vibrations.
The appliance
seems to make too
much noise.
The door will not
close properly.
Code Rev. E 20240815 (IEC)
POSSIBLE CAUSE
Appliance is not connected to a power
supply.
The appliance is turned off.
Circuit breaker has tripped or a fuse has
blown.
The temperature is not set correctly.
The ambient temperature could require a
different temperature setting.
The door was opened too often.
The door was not closed completely.
Door is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too
dusty.
The room temperature is higher than
average.
A large amount of bottles has been added to
the unit.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Appliance is not connected to a power
supply.
Circuit breaker has tripped or a fuse has
blown.
The light was switched off on the control
panel.
Light malfunctioning.
Door locked.
The appliance is not properly level.
The rattling noise may come from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and crackling noises.
The appliance is not properly level.
The appliance is not properly level.
The door was reversed and not properly re-
installed.
The gasket is dirty.
The shelves are out of position.
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or
replace fuse.
Check the set temperature.
Set a different temperature.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Clean the condenser when
necessary.
Clear the obstructions and clean
off the dust.
Put the appliance in a cooler
place.
Leave the appliance to work for a
while until the set temperature
has been reached.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Connect the appliance.
Switch on circuit breaker or
replace fuse.
Switch on the light.
Call for service to have it
replaced.
Unlock the door.
Level the appliance with the
adjustable feet.
Level the appliance with the
adjustable feet.
Level the appliance with the
adjustable feet.
Check the door hinge and
reassemble correctly.
Clean the door gasket.
Check the shelves and refit
correctly.
26
REMEDY
Publicité
