Publicité
SECURING THE APPLIANCE
Pop out the two cover caps on the opposite side of
hinge and secure the appliance in the niche by
tightening the screws through the attachment bracket if
the unit is provided with an attachment bracket.
Code Rev. E 20240815 (IEC)
OPERATING YOUR APPLIANCE
This appliance is designed for operation at certain
ambient temperatures. The climatic class is specified
on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range. For example, placing your unit in extreme cold
or hot conditions may cause interior temperatures to
fluctuate. The range between 5ºC and 20ºC (41ºF and
68ºF) may not be reached.
Climatic class
SN
N
ST
T
NOTE:
A unit with no heater will not raise its internal
temperature if the ambient temperature where the unit
is located is lower than the set temperature.
NOTE:
When you use the appliance for the
first time or restart the appliance after
having been shut off for a long time,
there could be a few degrees variance
between the temperature you select
and the one indicated on the LED/LCD
readout. This is normal and it is due to
the length of the activation time. Once
the unit is running for a few hours
everything will be back to normal.
If the unit is unplugged, has lost
power, or is turned off, you must wait
3 to 5 minutes before restarting the
unit. If you attempt to restart before
this time delay, the unit will not start.
USE AND CONTROL – SINGLE ZONE with
LED DISPLAY
The Controls of Your Unit
POWER
To turn the appliance off, lightly touch and hold the
key for 5 seconds until temperature display goes out.
To turn the appliance on, lightly touch and hold the
key for 1 second until temperature display lights up.
LIGHT
To turn the interior light on/off, lightly touch and hold
the
key for 5 seconds. The interior light indicator
13
Ambient room temperatures
+ 10°C to +32°C
+ 16°C to +32°C
+ 16°C to +38°C
+ 16°C to +43°C
Publicité
