Publicité
loosening the screws (8) & (9) and moving the
door adapter (7) & (10). Tighten the screws (8) &
(9) after the door is levelled.
11. Transfer the handles and plugs to the opposite
positions.
DESIGN 5 – For models with articulated hinge
1
3
WARNING
Use extreme caution with the articulated
hinges. The hinge is self-closing and many
pinch points exist prior to built-in installation.
1. Remove the cover caps (3) and then remove the
glass door by unscrewing the four screws (1) and
(2). Be careful to hold the glass door firmly after
removing the screws and place it on a padded
surface to avoid the risk of damage.
2. Pop out the cover caps on the left side of cabinet
and use them to
cover the screw holes on the right
hand side.
3. Rotate the glass door 180° and refit the glass door
to the opposite side. Then screw and tighten it after
the door is leveled.
DESIGN 6 – For freestanding models
1
2
2
5
6
1.
Remove the bottom hinge (3) by unscrewing the
four lock screws (4). Be careful to hold the glass
door firmly after removing the screws. (Fig. 1)
2.
Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then remove
the right top hinge (8). (Fig. 3)
Code Rev. E 20240815 (IEC)
1
2
3
3
4
3
9
7
8
7
3.
Unscrew and transfer hinge pin (5) and adjustable
leg (6) of the bottom hinge to the opposite side.
(Fig. 2)
4.
Pop out the cover caps on the left side of cabinet
and use them to
hand side.
2
5.
Screw the alternative left top hinge (9), included in
the fittings,
6.
Unscrew the four lock screws (2) and transfer the
door supporter (1) to the opposite side. (Fig. 1)
7.
Rotate the door 180° and relocate the door to the
designated position. Then screw the bottom hinge
assembly on the left designated position and
tighten it after the door is leveled.
ANTI-TIP BRACKET INSTALLATION
To reduce the risk of tipping the unit by abnormal
usage or improper loading, the appliance must be
secured by properly installing the anti-tip device (if your
model supplied with it) packed with the appliance.
Place the anti-tip bracket on the floor as shown in
the figure. An anti-tip bracket can be installed at
the left side.
Mark the locations of the 4 holes of the anti-tip
bracket on the floor.
Use an 8mm / 5/16" masonry drill bit and insert
plastic anchors.
Secure bracket to floor using screws.
Slide appliance into position and make sure the
leg engages the anti-tip bracket.
NOTE: If the unit is relocated, the bracket must be
removed and installed in the new location.
1
4
12
cover the screw holes on the right
on the left hand side of cabinet. (Fig. 4)
Publicité
