Publicité
For best results is recommended to:
Calibrate the probe before use and recalibrate periodically
Keep the electrode hydrated
Rinse the probe with the sample before use
Soak in MA9015 Storage solution for at least 1 hour before
measurement
MTC Mode
When the probe is not connected the "NO T. PROBE" message is
displayed. The MTC tag and the default temperature (25 °C) with
blinking temperature unit are displayed.
1. Press CAL/EDIT and use the keys to set the temperature
value manually.
2. Press GLP/ACCEPT to confirm or press ESC (or CAL/EDIT
again) to exit without saving.
Note: The temperature value used for MTC can be set only
when "NO T. PROBE" message is displayed.
8.4. WARNINGS & MESSAGES
Messages displayed during calibration
"WRONG BUFFER" message is displayed blinking when the
difference between the pH reading and selected buffer value
is significant. Check if correct calibration buffer has been used.
pH 27
Publicité
