Publicité
|
Disposal
7.2
Preparing for storage
1. Close the fastener system up to approx. 5 cm before the
end. Regularly check whether the fastener system is still
adequately greased.
2. Pull the flat bag supplied over the hood in such a way that
the cylindrical visor remains in shape.
3. If the chemical protective suit is folded together, pull the
supplied flat bag over the safety boots so that the
chemical protective suit is not discoloured.
7.3
Storing the chemical protective suit
The following storage options are possible:
– Lay the chemical protective suit flat during storage. If the
chemical protective suit is stored in the utility vehicle,
avoid wear due to constant friction against the storage
surface.
– Hang up the chemical protective suit on an appropriate
hanger or a hanging rail. The hood or safety boots must be
in contact with the ground.
– Fold up the chemical protective suit and store it in a
transport case, storage bay or carrying bag.
– Pack the chemical protective suit in a CPS storage and
transportation bag.
Dräger recommends packing the chemical protective suit in
the CPS storage and transportation bag to protect it from
environmental influences and to extend maintenance
intervals.
7.3.1 Folding up the chemical protective suit
Fold up the depressurized chemical protective suit
carefully.
Do not use force to bend the suit material, seams and
fastener system in the process. Avoid sharp bends.
1. Pull the flat bag over the hood.
2. Turn up the socks or safety boots once. Avoid sharp
bends.
3. Place the sleeves into the centre of the chest section.
Smooth out any creases.
4. Fold the hood and the upper section of the chemical
protective suit to ensure that the visor lies on the rolled up
safety boots. Smooth out any creases. Make sure that the
visor does not get deformed.
28
7.3.2 Packing the chemical protective suit in a
1. Place the chemical protective suit in the CPS storage and
2. Fix the visor using hook-and-loop straps.
3. Place the safety boots as illustrated.
4. Secure the chemical protective suit below the sleeves and
5. Fold up the sleeves on the shoulders and place on the
6. Close the CPS storage and transportation bag.
7. Turn up the CPS storage and transportation bag to the
8. Fold the CPS storage and transportation bag in the middle
8
8.1
The chemical protective suit must be withdrawn from service
00221840.eps
in the following situations:
– It has been damaged and repair is not possible.
– It was contaminated and cannot be decontaminated due
– The suit material has altered: for example, there are
In case of doubt please contact Dräger for more information.
8.2
If unused and if the recommended storage conditions and
maintenance intervals are met, the material properties of the
chemical protective suit are retained for at least 10 years from
17021963.eps
CPS storage and transportation bag
transportation bag.
on the boots using straps.
sides.
middle on the tip of the boots and directly under the visor
or on the neck, respectively. Ensure that the visor is
located between the gloves.
and close the strap buckles.
Disposal
Withdrawal from service
to the characteristics of the hazardous substance.
visible embrittled areas, bulges, colour changes, softened
areas on the surface.
Service life
Instructions for use
|
Dräger CPS 6900
Publicité
