Publicité
RADIO SYSTEM CONTROLS
Neutral
RADIO SYSTEM RULES
• Always turn your TQi transmitter on first and off last. This procedure
will help to prevent your model from receiving stray signals from
another transmitter, or other source, and running out of control. Your
model has electronic fail-safes to prevent this type of malfunction,
but the first, best defense against a runaway model is to always turn
the transmitter on first and off last.
• Always use new batteries for the radio system.
limit the radio signal between the receiver and the transmitter.
of the radio signal can cause you to lose control of your model.
TRAXXAS TQi RADIO & VELINEON POWER SYSTEM
1
1
Always turn your
transmitter on rst.
• In order for the transmitter and receiver to bind to one another, the
receiver in the model must be turned on within 20 seconds of turning
on the transmitter. Either the transmitter or receiver LED flashing
flash red indicates a failure to link. If you miss it, simply turn off the
transmitter and start over.
Brake/Reverse
• Always turn on the transmitter before plugging in the battery.
RADIO SYSTEM BASIC ADJUSTMENTS
Steering Trim
The electronic steering trim located on the
face of the transmitter adjusts the neutral
Forward
(center) point of the steering channel.
Note: Traxxas Stability Management (TSM) must be completely
turned off while adjusting steering trim. See page 17 for TSM
adjustments.
Multi-Function Knob
The Multi-Function knob can be
programmed to control a variety of
functions. From the factory, the Multi-
Function knob controls Traxxas Stability Management (TSM).
For more detail on TSM, refer to page 17.
Weak batteries will
Loss
www.modellmarkt24.ch
2
2
3
3
Plug in the batteries.
Turn on the model.
Remember, always turn the
TQi transmitter on rst and
o last to avoid damage to
your model.
Automatic Fail-Safe
The TQi transmitter and
receiver are equipped
with an automatic fail-
safe system that does not
require user programming.
In the event of signal loss
or interference, the throttle
will return to neutral and
the steering will hold its last
commanded position. If the
Fail-Safe activates while you
are operating your model,
determine the reason for
signal loss and resolve the
problem before operating
your model again.
Stop immediately at the rst
sign of weak batteries. Never
turn the transmitter o when
the battery pack is plugged
in. The model could run out
of control.
5 5
X-MAXX • 15
Publicité
