Graef batessa Instructions D'utilisation page 25

Place the filter insert for 2 cups in the group handle.
●
Insert the blind screen and place the tablet in the notch.
●
Clamp in the group handle.
●
Make sure that the drip tray has been inserted.
●
Press .
●
After 10 seconds, press
●
Repeat this process 4 times.
●
Then take out the group handle and remove the blind screen.
●
Put in the group handle without blind screen.
●
Press .
●
After 10 seconds, press
●
Repeat this process 4 times.
●
Now empty the drip tray and insert it back again.
●
EXTERNAL CLEANING
Use a soft and moist cloth to clean the outer surfaces of the unit.
●
Use a mild detergent in case of heavy contamination.
●
Pull out the drip tray.
●
Remove the drip tray.
●
Empty the drip tray.
●
Clean both under running water.
●
Then reinsert the drip tray together with the grille.
●
CLEANING TOOLS
Remove the cleaning tool, which you will find to the left of the water tank.
Using the thinner end of the cleaning tool, you can clean the holes of the filter inserts as well as the holes of the steam nozzle.
SETTINGS VIA THE P BUTTON
You have the option of making various settings using the "P"button. The unit must be switched on for the settings.
BREWING TEMPERATURE
Press the "P"button once.
●
This current setting for the brewing temperature is shown, e.g. CO TEMP 92 C.
●
To change this, press + or -.
●
Once you have selected the desired setting, wait a short moment until GRAEF appears on the display or confirm the setting directly with the
●
"P"button.
If you do not want to change anything, go to the next setting by pressing the "P"button.
●
STEAM QUALITY
Press the"P"button twice.
●
This current setting is shown, e.g. DAMPF 04 (factory setting). 01 is the smallest flow rate (dry steam) and 07 is the highest flow rate (humid
●
steam)
To change them, press + or-.
●
Once you have selected the desired setting, wait a short moment until GRAEF appears on the display or confirm the setting directly with the
●
"P"button.
If you do not want to change anything, go to the next setting by pressing the "P"button.
●
PRE-INFUSION
Press the "P"button 3 times.
●
This current setting is shown, e.g. PI MENGE P1 (factory setting).
●
To change it, press + or-. You can switch off the pre-infusion with P 0.
●
Once you have selected the desired setting, wait a short moment until GRAEF appears on the display or confirm the setting directly with the
●
"P"button.
If you do not want to change anything, go to the next setting by pressing the "P"button.
●
DESCALING REMINDER
Press the "P"button 4 times.
●
This current setting is shown, e.g. KALK 25 L (factory setting).
●
again.
again.
DE
EN
FR
NL
IT
PL
25