Publicité
Les langues disponibles
Les langues disponibles
en-us Operating the steam oven
9.4 Auto convection conversion
Convection bake and convection multi-rack modes require
a 25°F reduction in temperature. Auto convection
conversion reduces the temperature you enter
automatically.
Simply enter the package or recipe temperature when
¡
setting the mode. The control calculates the correct
temperature and it is shown in the display.
Note: This function is set to off as a factory default.
Operating the steam oven
10 Operating the steam oven
Food can be cooked very gently using steam.
Operating the steam oven
You can also use steam assistance with some
conventional heating modes.
WARNING
Hot steam may escape when the appliance door is
opened. Steam is not visible at certain temperatures!
Open the appliance door carefully during or after
▶
cooking.
Do not stand too near or lean over the appliance when
▶
opening the appliance door .
Note: There is a humming noise while the pump is in
operation and after switching it off. This noise is caused by
the pump function test. It is a normal operating noise. You
will also hear this noise after running non-steam modes
when the oven is turned off. This is normal.
10.1 Water tank
The steam oven is equipped with a water tank. When you
open the door you can see the water tank at the right side
of the oven cavity. Fill the water tank with water to operate
the appliance using steam modes.
NOTICE:
Use of inappropriate liquids can damage the appliance.
Do not fill the water tank with distilled water or any other
▶
liquids. For descaling use the descaling solution
specified in the section on descaling. → Page 45
THE WATER TANK IS NOT DISHWASHER SAFE.
Moisten the seal in the tank lid with some water before
¡
using it for the first time.
Use only fresh tap water or, if necessary, plain non-
¡
carbonated purchased water to fill water tank.
If your water is very hard (10 grains per gallon or
¡
higher), we recommend using softened water.
If your tap water is highly chlorinated (>4 mg/L), use
¡
plain non-carbonated purchased water with a low
amount of chlorine.
Filling the water tank
Most heating modes use steam. Ensure the water tank is
sufficiently filled before operation.
26
Requirements
You have read the important notes about the water
¡
tank.→ "Water tank", Page 26
You have set the water hardness level.→ "Setting the
¡
water hardness", Page 19
Open door and remove the water tank.
1.
The water tank is on the right side of the steam oven
cavity.
Moisten the seal in the tank lid with some water before
2.
using it for the first time.
Fill the water tank to the "MAX" line with cold water. The
3.
tank holds 1.4 quarts (1.3 liters) of water.
Close tank lid until it snaps.
4.
Publicité
