Preparing The Coating Material - WAGNER WallSpray Mode D'emploi

WallSpray
Translation of the original operating instructions
Before using the attachment, read these operating instructions and familiarise
yourself with the operating instructions for the basic unit. The safety instructions
for the basic unit apply to this WallSpray spray attachment.
The WallSpray spray attachment has been especially developed for the application of
interior wall paints. The WallSpray spray attachment can be used with all devices with the
CLICK&PAINT SYSTEM.
Coating materials suitable for use
Interior wall paint (dispersions and latex paint)
Coating materials not suitable for use
Low-viscosity materials
Materials that contain highly abrasive components, facade paint, caustic solutions and
acidic coating substances.
Flammable materials.

Preparing the coating material

Observe the manufacturer's instructions for the use of the coating material
on the paint tin or on the technical instruction sheet.
An absolute precondition for the trouble-free operation of the fine-spray system is that
the coating material is uncontaminated. If you have doubts as to the purity of the coating
material, we recommend that you first filter it through a fine sieve.
COATING MATERIAL
Interior wall paint
(dispersions and latex paint)
Assembly
For assembly, insert the spray attachment into the gun handle so that the two
arrows point at each other. Turn the gun handle 90° in the arrow direction until
it audibly engages. (Fig. 1)
To remove the spray attachment, push the catch (Fig. 1, A) beneath the trigger down and
turn the spray attachment by 90°.
PROCESSING
observe manufacturer's
instructions
COMMENTS
GB
3