Preparing The Coating Material - WAGNER WOOD&METAL EXTRA BRILLIANT Mode D'emploi

GB
Read the operating instructions carefully before using the tool and observe the safety
instructions. Keep the operating instructions in a safe place. The safety instructions
for the basic unit apply to this Brilliant spray attachment.
The Brilliant spray attachment was developed for applying water-soluble
paints and lacquers as well as paints and lacquers containing solvents.
The optimised nozzle and air guide are a guarantee of high quality surfaces
•
CAUTION! The units may only be used with a functional valve. If paints rises in the
ventilating hose (Fig. 1 A, item 12) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from different spray attachments.
The parts could be damaged.
1) Gun body
3) Nozzle seal
5) Air cap
7) Material quantity regulation
9) Container seal
11) Container
13) Valve cover
15) O-ring

Preparing the Coating Material

The paints usually need to be diluted for use with the spray gun. You can find informa-
tion on spray consistency for dilution on the material container or in the respective
manufacturer's data sheet (e.g. available on the Internet).
Otherwise, use the data in the viscosity table below as guide values (viscosity = consis-
tency of the coating material).
Measuring the Viscosity (Fig. 2)
1. Stir the coating material thoroughly before measuring.
2. Dip the viscosity test cup (16) completely into the coating material.
3. Hold the test cup up and measure the time in seconds until the liquid empties out.
Compare the measured "runout time" with the Viscosity Table.
6
General instruction
Description (Fig. 1)
2) Needle
4) Nozzle
6) Union nut
8) Trigger
10) Feed tube
12) Ventilating hose
14) Diaphragm
16) Viscosity test cup
Brilliant spray attachment