Preparing The Coating Material; Table Of Viscosities And Nozzle Sets; Starting Operation; Setting The Finecoat Spray Gun - WAGNER FineCoat 7000 S Mode D'emploi

Preparing the coating material

Observe the manufacturer's instructions for the use of the
coating material on the paint tin or on the technical instruc-
tion sheet.
Coating material purity:
An absolute pre-condition for the trouble-free operation of
the fine-spray system is that the coating material is uncon-
taminated. If you have doubts as to the purity of the coating
material, we recommend that you first filter it through a fine
sieve.

Table of viscosities and nozzle sets

Coating material Viscosity DIN-s
(4 mm DIN cup)
Solvent-based
lacquer paints
Water-soluble observe manufac-
lacquer paints turer's instructions
Wood preservatives
(scumble, mordants,
etc.)
Multi-color effect observe manufac-
materials, multi-color turer's instructions
paint
Texture and effect observe manufac-
paints turer's instructions

Starting operation

Before connecting to the mains supply make sure that the
mains voltage corresponds to the operating voltage on the
rating plate. The unit must be connected with a properly
earthed shockproof socket.
1. Screw air hose end (anti-kink spring) onto the turbo-blower.
Couple air hose to the paint spray gun.
2. Open closing lever on the paint container, remove paint
container.
3. Fill paint container with coating material.
4. Check that the paint container seal is clean and is seated
correctly.
5. Clip the container onto the spray gun and secure with the
closing lever.
6. Switch the turbo-blower on.
7. Point the paint spray gun at the object to be sprayed.
8. Determine the settings for the spray pattern, spray jet
width, amount of material, amount of air and ascending
feed pipe settings, see fig. 2 - 8 and the description page
14/15.
9. Operate trigger on the paint spray gun..
14
All manuals and user guides at all-guides.com
Nozzle set
No.
15 - 45 3 - 4
4 - 5
undiluted 2-3
6-7
5-6
GB

Setting the FineCoat spray gun

Spray pattern selection (fig. 2)
A = vertical flat jet for horizontal surfaces
B = horizontal flat jet for vertical surfaces
C = round jet for corners and edges and places difficult to
access.

Setting the required spray pattern (fig. 3)
Turn the air cap (1) to the required spray pattern position.
Attention:
Never pull trigger while adjusting the air cap settings.

1
FineCoat 7000 S