Parkside PBKS 53 A2 Consignes D'utilisation Et De Sécurité page 10

2. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
we wish you much pleasure and success in working with your
new device.
Note:
In accordance with the applicable product liability laws, the
manufacturer of this device assumes no liability for damage to
the device or caused by the device arising from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised special-
ists.
• Installing and replacing non-original spare parts,
• Application other than specified.
Note:
Read through the complete text in the operating manual be-
fore installing and commissioning the device.
This operating manual should help you to familiarise yourself
with your device and to use it for its intended purpose.
The operating manual includes important instructions for safe,
proper and economic operation of the device, for avoiding
danger, for minimising repair costs and downtimes, and for
increasing the reliability and extending the service life of the
device.
In addition to the safety instructions in this operating manual,
you must also observe the regulations applicable to the opera-
tion of the device in your country.
Keep the operating manual at the device, in a plastic sleeve,
protected from dirt and moisture. They must be read and care-
fully observed by all operating personnel before starting the
work.
The device may only be used by personnel who have been
trained to use it and who have been instructed with respect
to the associated hazards. The required minimum age must
be observed.
In addition to the safety instructions in this operating manual
and the separate regulations of your country, the generally
recognised technical rules relating to the operation of such
machines must also be observed.
We accept no liability for accidents or damage that occur due
to a failure to observe this manual and the safety instructions.
3. Device description (Fig. A - O)
1. Front hand guard
2. Front handle
3. Air filter cover
4. Start pull cord
5. Lock for the air filter cover
6. On/off switch
7. Fuel pump "primer"
8. Cold start lever (choke)
9. Throttle interlock
10. Throttle
11. Rear handle
12. Rear hand guard
13. Fuel tank cap
14. Chain oil fuel cap
15. Claw stop (pre-assembled)
16. Guide rail (pre-assembled)
17. Saw chain (pre-fitted)
18. Bench grinder aid
19. Oil adjustment screw
20. Fixing nuts
21. Chain tensioning screw
22. Chain cover
23. Chain tensioning pin
24. Chain catcher
25. Hole for the chain tensioning pin
26. Chain wheel
27. Guide bar cover
28. Hearing protection RYE001
29. Safety goggles RYF001
30. Mixing container
31. Spark plug wrench / slotted screwdriver
32. Bio chain oil
33. Air filter
34. Spark plug connector
35. Felling marks
4. Scope of delivery
• 1 chainsaw (premounted)
• 1 Spark plug wrench / slotted screwdriver
• 1 Cover for the guide bar (chain guard)
• 1 Mixing container
• 500 ml organic chain oil (Made in Germany)
• 1 Safety goggle RYF001
• 1 Hearing protection RYE001
• 1 operating manual
5. Proper use
The chainsaw may only be used for cutting wood outdoors.
The chainsaw must not be used for any other purpose.
Do not use the chainsaw for work for which it is not intended.
Example: Do not use the chainsaw to saw metal, plastic, brick-
work or building materials other than wood.
Do not make any modifications to the chainsaw. Safety may
be compromised as a result. The user/operator, not the manu-
facturer, is responsible for damages or injuries of any type re-
sulting from this. Please note that this device was not designed
for commercial use.
First-time users must be instructed to familiarise themselves with
the features of the device. Attend a state chainsaw training
course for your safety.
The chainsaw may only be operated by persons who are
aged 18 and above.
An exception to this is use by minors if the use takes place
as part of occupational training in order to gain proficiency
under the supervision of an instructor.
GB/IE/NI/CY/MT 5