Procopi Piscines Bois TROPIC OCTO Notice De Montage page 76

» »
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS/ OCTO & OCTO +
ASSEMBLING AND INSTALLING ThE STAINLESS STEEL LADDER
> >
78
Assemble the various parts of the ladder referring to
the installation instr uctions provided.
When mounting the hand rails, do not forget the
two rubber seals that will be used to hold the decorative
escutcheon plates in position.
ASSEMBLING AND POSITIONING ThE WOODEN LADDER
> >
80
76
/ OCTO & OCTO +
73
Position the ladder in the pool on the coping module
of your choice (except the wall holding the skimmer
and counter swim module), remember that it should be
opposite the wooden ladder.
Adjust the position of the ladder paying particular
attention to ensure that it is vertical and that the
bumpers are pressed firmly against the inside wall.
Mark the positions for drilling. remove the ladder and
drill.
Fix the ladder in place according to the instructions
provided, the counter plate should be positioned under
the coping (additional bag in the Filtration pack). Tighten
moderately.
Slide the 2 rubber seals along the tubes so that they hold
the escutcheon plates in position.
The stringers and the treads for the wooden steps are in
the Wood kit. Assemble the wooden steps using the SS
screws (bag K). For cleaner, more efficient assembly, we
recommend that you pre-drill the various elements (4 mm
drill bit) and mill the holes to avoid splitting the wood and
raising splinters.