Procopi Piscines Bois TROPIC OCTO Notice De Montage page 75

» »
ASSEMBLY ASSEMBLY INSTRUCTIONS INSTRUCTIONS/ OCTO & OCTO +
INSTALLATION Of ThE COPING ON OCTO + 640 POOLS
> >
72
Screw a mounting plate to the top of each wooden
bracket (wooden bracket kit) . Make sure that each plate
is flush with the top of the walls.
74
Attach the coping elements to the mounting plates on the support brackets using roofing screws (bag G and h) as
shown. Pre-drill lightly to ease driving of the screws. Check continuously that the coping elements are correctly aligned.
The exterior plank located above the skimmer is joined to the interiour plank with two hinges (bag A).
Do not attach it to the support bracket mounting plates. The hinges allow the exterioir plank to be raised to provide access
to the skimmer. It should be held in place with latches. (see below).
76
All that remains is to attach the 8 coping corner connecting brackets (mounting kit in the coping pack) as shown above,
taking care to position the brackets correctly
Attach the latches (bag N) as shown.
/ OCTO & OCTO +
73
The coping comprises 10 interior planks & 10 exterior
planks. Arrange the planks on the the support brackets
as shown. The interior planks overlap the pool by
approximately 25mm from the edge of the wall. Make
sure that the elements are correctly positionned around
the periphery of the pool.
The coping is 290mm wide with a gap of around 5mm
between the interior and exterior planks.
On longer length, itt may be necessary to reinforce
the coping in places using a bracket mounting plate.
75
77
75