Filtration Group - Procopi Piscines Bois TROPIC OCTO Notice De Montage

»
ASSEMBLY INSTRUCTIONS/ OCTO & OCTO +
ASSEMBLING AND COMMISSIONING ThE fILTER GROUP
> >
Before you continue to fill the pool, assemble the filter group. refer to the sand filter installation instructions
and the pump operating instructions. Study the filtration system diagram and the table opposite that lists the main
components and the composition of the various packs.
CAUTION ! ! ! The pump power supply absolutely must be protected by a 30 mA differential circuit breaker
mounted upstream from the installation.
Similarly, follow all the installation instructions set out in the manuals enclosed with the underwater
light and the control panel.
The filtration system, like every other electrical device, must be wired in in accordance with the standards in effect in
Do not hesitate to call on the services of a professional to guarantee the compliance of your installation.
We strongly recommend that you install the filter below the water level. If the filter is installed above the water line, there
is a risk of deformation due to depresssurisation. The maximum allowed is level with the coping. In the event that the
filter is installed above the water line, a check vent must be mounted on the return line and an inspection check valve
must be mounted on the suction line (these items are available from any pool specialist).
FILTRATION GROUP COMPONENTS AND ChARACTERISTICS
Description
Filtration TrOPIC (360, 414, 505, +460,
+540, +610, +640 pools)
ref Description
B Floating hose D38 mm
D rubber sleeve + collar clamp
E Pump/filter connection hose
G Pump
I Skimmer assembly
I1 Skimmer lid
I2 Skimmer basket
I3 Skimmer gasket
I4 Skimmer screw 5.5 x 25
I5 Skimmer gasket
I6 Skimmer weir
I7 Cache bride de skimmer
I8 Skimmer body
J Union under the skimmer
1 Filter tank
1 diffuser
64
the country of installation (C15-100 in France).
Flow rate m /h with
3
directional nozzle
5.37
1 lid with multi-port valve,
pressure gauge and unions
1 collector
Pump Filter diameter
in mm
Aqua-tropic 400
4m
ref Description
L Pressure gauge
O return fitting assembly
O1 return fitting body
O2 return fitting gasket
O3 return fitting flange
O4 Directional jet return fitting face plate
P Drain plug + o-ring
q Collector pipe with plug
r Collector plate
S Lid
V Lid holding ring
W Lid holding ring o-ring
X Diffuser
Z Filter tank
1 lid holding ring
1 lid holding ring o-ring
Sand Filtration sur- Volume filte-
face area in m² red in 24h
1 x 25 0.125 128.9
kg
1 collector tube with plug
1 drain plug with o-ring