Procopi Piscines Bois TROPIC OCTO Notice De Montage page 63

»
ASSEMBLY INSTRUCTIONS
57
Glue the second skimmer gasket to the interior surface of the skimmer flange. (The interior surface has sharp edges
while the exterior surface has rounded edge).
Locate the 4 corner holes of the skimmer mouth and mark them with a pen.
Position the flange such that its corner holes are aligned with the points marked in pen.
Use a small screw driver or punch to pierce the liner at the 4 points marked and fix the flange in position with the
gasket against the liner. Once the 4 corner screws are in place, continue, inserting a screw through each hole. Avoid over
tightening, this could deform the flange. Tighten the screws alternately to ensure an even and leaktight fit.
59
60
Screw the multi- directional eyeball assembly into the return fitting
body. The eyeball should be pointed left to facilitate the flow of water
necessary for efficient filtration.
(Prior to assembly, apply a layer of silicon grease to the eyeball and its
housing to facilitate its movement and subsequent removal).
/ OCTO & OCTO +
58
Cut away the liner inside the flange. Keep the
off-cuts for future repairs.
Clip the weir into place, smooth surface facing
the pool. The weir should be able to swing freely.
Mount the skimmer face plate.
The skimmer basket is passed through the
skimmer mouth, swing the weir towards the pool to
make space.
Place the lid o n the skimmer.
(these parts can be found in the Pool Fitting skin
pack)
63