Procopi Piscines Bois TROPIC OCTO Notice De Montage page 67

»
ASSEMBLY INSTRUCTIONS
fILTER ASSEMBLY (CONT.)
> >
Check that the upper, inner part of the tank is clean.
remove the protective cap from the collector tube.
To facilitate fitting of the lid, grease the interior of
the top part of the tank (silicon grease).
Position the lid flat over the tank and push down
evenly to engage the lid into the tank.
Once in position, the lid should be up against the
top of the tank and the o-ring should no longer be
visable.
Waste
Filtered water outlet
/ OCTO & OCTO +
Unfiltered
water inlet
Screw the holding ring into position to keep the lid
in position.
hand tighten by a qaurter turn.
CAUTION :
An incorrectly fitted lid could have the following reper-
cussions:
- Discharge of sand through the return fitting
- Water leaking from the waste outlet.
- Leaks from the filter tank.
In filtration mode, a weak flow from the waste outlet is
normal.
67