Procopi Piscines Bois TROPIC OCTO Notice De Montage page 62

»
ASSEMBLY INSTRUCTIONS/ OCTO & OCTO +
fITTING ThE LINER (contd.)
> >
52
53
Stick the self-adhesive gaskets to the return fitting and
vacuum fitting flanges.
55
Screw the flange (fitted with its gasket) into place using
the countersunk SS screws M5x16 from the pool fitting
skin pack. Tighten the screws alternately to ensure a
leaktight fit. hand tighten, over tightening could damage
the flange.
62
Once the liner has been hung and is correctly
positioned, fill the pool with 2 cm of water. Push any
creases towards the walls smoothing out the liner as
much as possible.
This operation will not be possible if the pool is
empty or overfilled (contains more than 2 cm of water).
Once the liner is correctly hung and positioned and
creases have been eliminated, continue filling the pool
until the water level is 10 cm below the first pool fitting
(underwater light or return fitting depending on their
position).
54
Locate the holes in the throughwall flange and mark
them. .
56
Cut out the liner inside the vacuum fitting and return
fitting flanges.