Procopi Piscines Bois TROPIC OCTO Notice De Montage page 53

»
ASSEMBLY INSTRUCTIONS
ASSEMBLY Of ThE OCTO POOL STRUCTURE (contd.)
> >
hold the track in position using a screw placed 2 cm from each end. Then complete attachment of the track by inserting
screws at 20 cm intervals.
14
FITTING THE UNDERLAY:
Important !
The ground underneath the underlay should be absolutely flat and free of any bumps or rough areas.
Because of the pressure exerted by the water, even the smallest bump will be visible underneath the liner. After clearing
the ground, spread a layer of sand mixed with cement (1 part cement to 7 parts sand) over the floor of the pool and
compact it. This layer should be no more than 1 cm deep. (The sand and cement are not supplied). Unfold the underlay
in the pool taking care to line it up correctly with the corners. Smooth out any wrinkles. The underlay will be slightly
smaller than the pool structure.
/ OCTO & OCTO +
13
15
53