Procopi Piscines Bois TROPIC OCTO Notice De Montage page 52

»
ASSEMBLY INSTRUCTIONS/ OCTO & OCTO +
ASSEMBLY Of ThE OCTO POOL STRUCTURE (contd.)
> >
10
The are 3 wooden brackets per side (except the side
holding the skimmer). Position 1 wooden bracket in the
centre of the slat, the other 2 equidistant on either side of
it (D2 in the table).
IMPORTANT !
Check that the structure is correctly assembled
before mounting the liner locking track.
To do this:
- use a spirit level to check that the structure is
horizontal around the entire periphery.
- check that the 4 diagonals are equal in length.
Fix any imperfections before continuing.
The liner locking track should be flush with the top of
the wooden structure.
Before mounting the liner locking track, pre-drill using
a Ø 3mm drill bit.
Avoid over tightening, this could cause the screws to
break through the track.
Each side of the pool is fitted with one track 1.18 m long and another track trimmed to fit, see the table below.
Trim 8 tracks according to the table below. before making the cuts, check that the total length of the track is equal to the
length of the wall less 10 cm. Use a mitre box to ensure that the cuts are clean and straight. Deburr the cuts using the
fine grain file.
52
11
Mount 2 wooden brackets on the wall holding the
skimmer, they should be positioned 75.5 cm apart and
equidistant from the skimmer axis.
12
Pool model Short side
360 1.14
414 1.18+0.26
505 1.18+0.61
+460 1.14
+540 1.14
+610 1.18+0.26
+640 1.18+0.26 1.18+1.18+1.18+0.29
Long side
1.18+1.18+0.28
1.18+1.18+0.88
1.18+1.18+1.18