Procopi Piscines Bois TROPIC OCTO Notice De Montage page 73

»
ASSEMBLY INSTRUCTIONS
fITTING ThE COPING TO OCTO POOLS (except + 640)
> >
65
Note the distribution of the various modules constituting the coping on the drawing. Arrange them on the coping
support brackets. Make sure that the elements are correctly and evenly positioned around the entire periphery of the
pool. Adjust them if necessary and make sure that they remain in position until screwed in.
67
Attach the 7 coping planks of the same length. Be careful
to drive the screws into the centre of thet wooden walls to
avoid damaging them. (screws from bag T)
69
Screw the two side elements in position as shown.
/ OCTO & OCTO +
66
68
Before fastening the 3 parts of the coping over skim-
mer in position, pre-drill the central element and the
two side elements at the points inidcated above. Make
sure that the holes (6mm) are drilled very precisely and
that they are properly aligned. Insert the pivots (bag ref
27511070), then replace the coping elements.
70
All that remains is to attach the 8 coping corner connect-
ing brackets (bag 27511671) as shown above, taking care
to position the brackets correctly.
73