Procopi Piscines Bois TROPIC OCTO Notice De Montage page 55

»
ASSEMBLY INSTRUCTIONS
ASSEMBLY Of ThE OCTO + POOL STRUCTURE (contd.)
> >
recommendations and advice:
- Before beginning assembly, identify the various slat types with reference to the exploded view at the end of this
document.
- Establish the final orientation of your pool, the skimmer should be oriented facing into prevailing winds. The skimmer
should be mounted on a side that starts with a type A slat.
- While assembling the walls, make sure that each slat is fully engaged before starting on the next.
- You may need to use a hammer and a clamp to remedy any slight warping of the slats. Do not strike the wood directly,
use the protective brace (provided).
- During assembly, check regularly that the walls are level and the 4 diagonals are equal in length.
- To avoid the risk or injury or damage to the liner, take care to eliminate any splinters during and after assembly.
- Please refer to the various illustrations provided in this document.
-If you intend to fit your pool with a counter swim treadmill, you will need to encorporate the 2 slats specially prepared
to mount this option.
460+ pool: for these assembly steps refer to the illustrations on page 60-61
20
540 & 640+ pools
21
Fit the remaining slats together using type B slats on the short sides and type D slats on the long walls. Take care to
correctly position the pierced slats (type E) that will hold the return and vacuum fittings, the bottom skimmer slat (type F)
and, if necessary, the 2 optional slats from the counter swim treadmill kit. (refer to the exploded view at the end of this
document for the position of these slats). The slat that will hold the return fitting (E) should be positioned above 4 type
B slats + 1 type A slat. The type F slat should be located above the return fitting slat in the last row at this point in the
assembly procedure. The second type E slat can be used to hold the vacuum fitting. Note its position in the exploded
view at the end of this document. The opening in this slat sould be sealed with the foam plug provided.
/ OCTO & OCTO +
Fit together the two type A half slats and the two type C
half slats and the 4 type B slats as shown in the diagram,
with the male side (tongue side) facing up.
22
55