Assembly Of The Octo Pool Structure - Procopi Piscines Bois TROPIC OCTO Notice De Montage

»
ASSEMBLY INSTRUCTIONS

ASSEMBLY Of ThE OCTO POOL STRUCTURE

> >
5
Fit the 4 half slats (type A - smooth side facing down) together with 4 male/ female slats (type B), grooves facing down,
double tongues facing up (see the detail below).
6
Fit together the remaining slats (type B) taking care to
position the slat that will hold the return fitting (type C)
and the bottom skimmer slat (type D) correctly. The slat
that will hold the return fitting should be positioned over
4 (type B) slats + 1 type A slat. The second machined slat
(C) will hold the vacuum fitting. Note its position on the
exploded view at the end of this document. The opening
in this wall should be blocked with a foam plug. The type
D slat is positioned on the same side in the last row of
this step.
8
Fit the top skimmer slat (type E) over the bottom skimmer
slat (type D), and continue around the pool with 3 type F
slats and 4 type G half-slats as illustrated.
/ OCTO & OCTO +
- Before you begin, familiarise yourself with the
nomenclature enclosed in the "Waterproofing" kit and the
exploded view (at the end of this notice) that corresponds to
your pool.
- Determine the final orientation of your pool, by preference,
the skimmers should be oriented so that they are facing into
the prevailing winds. Skimmers must be mounted on a side
that starts with a type A slat.
- While assembling the walls, make sure that each slat is fully
engaged before starting on the next.
- You may need to use a hammer and a clamp to remedy any
slight warping of the slats. Do not strike the wood directly,
use the protective brace (provided).
- During assembly, check regularly that the walls are level
and the 4 diagonals are equal in length.
- To avoid the risk of injury or damage to the liner, take care
to eliminate any splinters during and after assembly.
-If you intend to fit your pool with a counter swim treadmill,
you will need to encorporate the 2 slats specially prepared
to mount this option.
7
At this point, fit the skimmer into the bottom skimmer slat
(type D) .
9
The wooden brackets will support the coping that will be
mounted after the pool is filled. Pre-drill the wall from
inside the pool then attach each wooden bracket (type l)
using 2 screws (5x100mm sachet J) taking care to position
them 3mm below the top of the structure. remove any
splinters that may have been raised during this process.
51