Procopi Piscines Bois TROPIC OCTO Notice De Montage page 56

»
ASSEMBLY INSTRUCTIONS/ OCTO & OCTO +
ASSEMBLY Of ThE OCTO + POOL STRUCTURE (contd.)
> >
At this point, fit the skimmer into the machined slat (F). Slot the top skimmer slat (G) over slat F and continue around the
pool, fitting 2 type h slats, 1 type l slat and 4 type J half-slats into position as shown.
Working from the outside, screw the metallic posts (pre-
drilled) onto the wooden walls using 6x40mm screws from
bag C. Check their verticality. Position two decorative
profiles (q) on either side of each post and fasten them
together using 3 5x70 screws (bag C) as shown.
56
23
26
27
The short sides of the 460 and 540 models should be fitted
with 2 brackets.
The short sides of the 640 model should be fitted with 3
brackets except for the side holding the skimmer which
should be fitted with 2 brackets. (image 44).
25
The wooden brackets are designed to support the coping
after the pool is filled. Pre-drill the wall, then, working
from inside the pool, fasten each coping support bracket
(L) in position using 2 5x100mm screws (bag r), taking
care to ensure that each bracket is 3mm beneath the
top of the pool structure. Check the verticality of each
support bracket.
540 & 460 60 cm
640 40 cm