Procopi Piscines Bois TROPIC OCTO Notice De Montage page 59

»
ASSEMBLY INSTRUCTIONS
ASSEMBLY Of ThE OCTO + 460 POOL (CONT.)
> >
ASSEMBLY Of ThE WOODEN STRUCTURE
35
Fit together the two type A half slats and the two type C
half slats and the 4 type B slats as shown in the diagram,
with the male side (tongue side) facing up.
37
DRESSING ThE CRADLES
38
After checking that the verti-
cal posts are perfectly vertical,
screw them into the wooden
structure using 4 screws from
bag C.
/ OCTO & OCTO +
39
Put the three 20x120 slats to-
gether to form a U to hide the
metallic posts (bag C, SS screws
5x7). Pre-drill the holes before
inserting the screws.
36
illustration 36 Fit the remaining slats together using
type B slats on the short sides and type D slats on the
long walls. Take care to correctly position the pierced
slats (type E) that will hold the return and vacuum fittings,
the bottom skimmer slat (type F) and, if necessary, the 2
optional slats from the counter swim treadmill kit. (refer
to the exploded view at the end of this document for the
position of these slats). The slat that will hold the return
fitting (E) should be positioned above 4 type B slats + 1
type A slat. The type F slat should be located above the
return fitting slat in the last row at this point in the assem-
bly procedure.
illustration 37 At this point, fit the skimmer into the ma-
chined slat (F). See image 8.
Slot the top skimmer slat (G) over slat F and continue
around the pool, fitting 2 type h slats, 1 type l slat and 4
type J half-slats into position as showné
Once the walls are assembled, mount the wooden coping
brackets (illustrations on page 59).
40
Position the decorative structure over the post.
Make sure that the top of trhe structure is flush
with the top of the wooden wall. Working from the
inside of the pool, pre-drill the holes and fix it in
position. Nexxt, check that there are no splinters
that could damage the liner.
41
59