Publicité
Les langues disponibles
Les langues disponibles
1) Use the blender e to purée foods.
Whisks r
Kneading
hooks t for
for stirring
kneading
batter or cake
heavy doughs,
mixture or
e.g. yeast
for whipping
dough.
cream.
2) Open the safety catch of the blender socket 4
by pushing it to the side and holding it firmly.
Note: The blender e can only be used if the
whisks r or the kneading hooks t are not
installed.
3) Push the blender e into the blender socket 4
and push it down firmly. The blender e must
audibly click into place.
4) To avoid overflowing, the container used for
blending should only be filled to about 2/3 of
its capacity. Select a suitably large container.
Note: Ensure that there is a sufficient amount
of liquid/purée in the purée container.
To ensure effective mixing of the ingredients,
the food should cover at least the lower section
of the blender e.
Do not switch the hand mixer on until the
blender e has been inserted into the ingredi-
ents.
5) Press the Turbo button / 2. Keep the Turbo
button / 2 pressed down during the whole
procedure. The appliance stops as soon as it
is released.
ATTENTION! PROPERTY DAMAGE!
Do not operate the blender e for longer than
►
1 minute at a time. After one minute of use,
allow the appliance to cool down fully.
│
GB │ IE
■
8
6) When you have finished working with the
►
7) To remove the blender e from the blender
Blender e
for puréeing
fruits/
vegetables,
e.g. apples.
8) Remove the blender e with a snapping motion
Cleaning
►
►
►
►
■
■
blender e, release the Turbo button/ 2 and
remove the mains plug from the power socket.
ATTENTION! PROPERTY DAMAGE!
Clean only the lower section of the blender e
under running water. Do not allow water to
get inside the blender e. This could result in
damage to the appliance.
socket 4 , press the blender release button 3
on both sides of the hand element q at
the same time. The blender e is now released
from the blender socket 4 .
from the blender socket 4 .
Note: If the blender e still cannot be
removed from the blender socket 4 , pull the
safety catch open a little. Then the blender e
can be removed.
DANGER!
RISK OF ELECTRICAL SHOCK!
Before cleaning the appliance, disconnect
the power plug from the mains power socket!
There is a risk of electric shock!
Never immerse the hand element q in
water or other liquids!
WARNING! RISK OF INJURY!
Take care when cleaning the blender e!
The blade is extremely sharp!
Never submerge the blender e
completely under water. Clean only the
lower part with the blade under running water.
Otherwise, the appliance could be irreparably
damaged.
Clean the hand element q containing the
motor using a damp cloth only; if necessary,
add a little mild detergent.
Clean the mixer stand 7 using a damp cloth
only; if necessary, add a little mild detergent.
SHMS 300 D2
Publicité
