SilverCrest 425200 2301 Mode D'emploi page 10

5) Replace the mixing bowl 8 on the mixer
stand 7.
6) Press the mixer holder release 6
the mixer holder 7 back downwards.
7) Place the hand element q on the mixer
holder 7 so that it firmly clicks into place.
8) Push the lid 0 into the rails on the mixer stand 7
so that it sits firmly in place.
Note: If you want to add ingredients during
mixing, open the filling opening 9 on the lid
0 and add the ingredients. Close the filling
opening 9 afterwards to prevent ingredients
from spraying out!
You can use the hand mixer without the mixer
stand 7. We recommend using the hand mixer
without the mixer stand 7 especially for small
amounts of liquid. Otherwise, the mixer cannot
reach all the liquid and it may not be properly mixed.
WARNING! RISK OF INJURY!
► Never use containers made from glass or other
easily breakable materials. These containers
may be damaged and cause injuries.
9) Insert the plug into a mains power socket.
10) To start up the appliance, move the speed
switch 1 to the desired speed setting. You can
choose between 5 speed settings and also
use the Turbo button/ 2 (see section "Speed
levels").
Note: If ingredients stick to the edge of the
mixing bowl 8 and cannot be reached by the
kneading hooks t/whisks r, switch off the
hand mixer. Remove the lid 0. Use the dough
scraper z to push the stuck ingredients back
into the middle of the mixing bowl 8. Replace
the lid 0. Switch the hand mixer back on.
11) To remove the contents of the bowl, switch off
the hand mixer. Pull the lid 0 off to the side.
Note: For safety reasons, the whisks r and
kneading hooks t can only be released if the
speed switch 1 is set to the position "0".
12) Press the mixer holder release 6
mixer holder 7 and remove the mixing bowl 8
from the mixer stand 7. You can now remove
the contents of the bowl.
SHMS 300 D2
13) Press the tool-release button w to release the
whisks r or the kneading hooks t.
and swing
For safety reasons, the whisks r and kneading
hooks t can only be released if the speed
switch 1 is set to the position „0".
Note:
the
Press the hand mixer release button 5
(1) while at the same time tipping the back
part of the hand element q upward (2). You
can then pull off the hand element q at an
angle toward the front/top (3):
Puréeing
WARNING! RISK OF INJURY!
► Never use containers made from glass or other
easily breakable materials. These containers
may be damaged and cause injuries.
ATTENTION! PROPERTY DAMAGE!
Never use the blender e for hard foodstuffs
►
such as: coffee beans, ice cubes, sugar, cereals,
chocolate, raw/hard vegetables etc. This could
result in serious damage to the appliance.
Do not use the blender e to purée boiling
►
food (e.g. soups). Remove the pot from the
hotplate before puréeing.
, flip up the
To remove the hand element q from
mixer stand 7
, proceed as follows:
1
GB │ IE │
7 ■