Input Of The Centrifugation Parameters With The "Select" Key - Hettich HAEMATOKRIT 200 Mode D'emploi

15.2

Input of the centrifugation parameters with the "SELECT" key

The runtime can be set in minutes and seconds (parameters t/min and t/sec ).
In order to set the continuous run, the parameters t/min and t/sec must be set to zero. In the time display
(t/min:s), " --:-- " appears.
Example:
>RCF< RPM t/min:s
The relative centrifugal force (RCF) depends on the centrifuging radius (RAD). After entering the RCF, check
to make sure that the correct centrifuging radius has been set.
If no key is pressed for 8 seconds after selection or during parameter input, the previous values are shown on
the display. The parameters must then be input again.
If several parameters are input, the
Entering parameters can be cancelled at any time by pressing the
stored.
 Press the key to activate the RPM display
RCF
(RPM) or the RCF display ( RCF ) as
needed.

 Press the key.
SELECT
t/min : Runtime, minutes.

 Set the desired value with the keys.
t

 Press the key.
SELECT
t/sec : Runtime, seconds.

 Set the desired value with the keys.
t

 Press the key.
SELECT
RPM Speed.
RCF : Relative centrifugal force.

 Set the desired value with the keys.
t

Continued on next page
START
PULSE
key must be pressed after setting the last parameter.
Example:
RPM display (RPM)
>RCF< RPM
>RCF< RPM
>RCF< RPM
>RCF< RPM
>RCF< RPM
>RCF< RPM
>RCF< RPM
STOP
OPEN
key. In this case, the settings are not
Example:
RCF display ( RCF )
t/min:s >RCF< RPM
t/min:s >RCF< RPM
t/min:s >RCF< RPM
t/min:s >RCF< RPM
t/min:s >RCF< RPM
t/min:s >RCF< RPM
t/min:s >RCF< RPM
EN
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
51/129