Input Of The Centrifugation Parameters With The "Select" Key - Hettich EBA 200 Mode D'emploi

15.2

Input of the centrifugation parameters with the "SELECT" key

The runtime can be set in minutes and seconds (parameters t/min and t/sec).
In order to set the continuous run, the parameters t/min and t/sec must be set to zero. In the time display
(t/min:s), "--:--" appears.
Example:
>RCF< RPM t/min:s
The relative centrifugal acceleration (RCF) depends on the centrifuging radius (RAD).
During the input of the RCF, the set centrifuging radius is displayed.
If no key is pressed for 8 seconds after selection or during parameter input, the previous values are shown on
the display. The parameters must then be input again.
START
PULSE
By pressing the
If several parameters are input, the
Entering parameters can be cancelled at any time by pressing the
stored.
 Press the key to activate the RPM display
RCF
(RPM) or the RCF display ( RCF ) as
needed.

 Press the key.
SELECT
t/min : Runtime, minutes.

 Set the desired value with the keys.
t

 Press the key.
SELECT
t/sec : Runtime, seconds.

 Set the desired value with the keys.
t

Continued on next page
AB18000DEENFRIT
button, the settings will be saved.
START
PULSE
key must be pressed after setting the last parameter.
Example:
RPM display (RPM)
Rev. 05/ 05.2020
STOP
OPEN
key. In this case, the settings are not
Example:
RCF display ( RCF )
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
EN
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
57/146