LEGRAND KEOR XPE Serie Manuel De L'utilisateur page 53

KEOR XPE UPS user manual
Manuel de l'utilisateur de l'ASI KEOR XPE
Utilizzo dell'UPS KEOR XPE
5.4.3.2 Battery setting – Distributed Battery configuration
If the system is configured as a Distributed Battery, the screen will appear as below.
Figure 29 – SETTINGS section - BATTERY PARAM. – distributed battery config. (System)
In this case, the capacity, recharge current and autonomy parameters refer to the battery
connected individually to the various Power Units.
For example, clicking on the POWER UNIT CAPACITY control, you access the screen below,
where you can set the capacity of each system Power Unit.
Figure 30 – SETTINGS section – BATTERY CAPACITY – distributed battery config. (System)
5.4.4 New battery
The NEW BATTERY function allows you to set the maximum charge and autonomy status of
the system battery; this is because the system on start-up is not immediately capable of
establishing the charge and autonomy status of the battery.
OMAF9213 REV. C 53