Machine Disassembling; Demolishing The Machine; Disposing Of Harmful Substances - OEM PULSAR Mode D'emploi

PULSAR
Dismantling - Demolition - Disposal
Chapter 7

7.1 - MACHINE DISASSEMBLING

In the event the machine shall be disassembled, to
install it again you shall proceed in the reverse order
in comparison with the instructions reported in "Instal-
lation" chapter.
Before disassembling the machine or demounting
some machine components, disconnect the power
supply.
The machine assembling shall only be carried out
by skilled and authorized personnel.
ATTENTION
In case it is necessary to disassemble the machine
or demount some machine components in a differ-
ent way in comparison with the written instructions,
Company OEM or its Agent shall be contacted - see
addresses on the third page of this publication.

7.2 - DEMOLISHING THE MACHINE

Proceed as described below if the machine is to be
scrapped for any reason:
• Disconnect the machine by complying with the instruc-
tions given in chapter "Installation" of this publication,
working in reverse order.
• Disassemble all possible machine components (cas-
ings, lamps, guards, handles, chains, motors, etc.)
and divide them according to their different nature
(eg.: pipes, rubber components, lubricants, solvents,
coating products, aluminium, ferrous materials, cop-
per, glass, etc.).
• Before scrapping the machine, notify the competent
authorities by written communication in compliance
with the laws in force in each individual country.
• After having received authorization from the above
mentioned authorities, dispose of the machine com-
ponents as prescribed by the current provisions in
merit.
DANGER
ATTENTION
Consult the next paragraph when disposing of
harmful materials (lubricants, solvents, coating
products, etc.).

7.3 - DISPOSING OF HARMFUL SUBSTANCES

Consult the provisions established by the Standards
in force in each individual country before disposing of
such substances.
ATTENTION
Any improper use by the Customer before, during
or after scrapping and disposing of the parts of
the machine, in respect of the construction and
application of the applicable regulations, shall be
the customer's responsibility.
EN - 29