B - B Outer Cleaning; B - C Refractory Surface Cleaning; Scheduled Service Interventions; Service Intervention According To The Specific Requirements - OEM PULSAR Mode D'emploi

6.1.b.b - Outer cleaning
ATTENTION
At the end of each working cycle, carefully clean
the oven.
To clean the oven, NEITHER metallic objects such
as steel wool, brushes, scrapers NOR corrosive
products shall be used.
Do NOT utilize water jets to clean the oven sides.
• To clean the outer side of the oven, you shall use a wet
cloth as well as a detergent suitable for the surface to
be treated.
6.1.b.c - Refractory surface cleaning (Fig 2)
• Make sure the oven is totally cool, oepn the door and
clean the refractory surface (1) by the special scrubber.
6.1.c - Scheduled service interventions
• According to the hours of use and the operating load,
it is possible to schedule service at least once a year.
6.1.d - Service intervention according to the spe-
cific requirements
6.1.d.a - Lamp replacement (Fig. 3)
• Turn the nut with fins (1) to an horizontal position
• Remove the small L-shaped bracket "L" (2) including
the lamp-holder and then replace the lamp.
ATTENTION
It is an halogen lamp do NOT touch with your fingers.
EN - 28
PULSAR
Maintenance
FIG. 2
FIG. 3