Reference Normatives; Description Of The Symbols; Important; Machine Composition - OEM HENERGO HV/45 E-1 Mode D'emploi Et D'entretien

- THESE SAFETY REGULATIONS INTEGRATE OR COM-
PLEMENT THE LOCAL SAFETY REGULATIONS.
- DO NOT make hurried or inaccurate repairs that may
compromise the good running of the machine and the
safety of the operator.
- IN CASE OF DOUBT ALWAYS ASK FOR THE PRESENCE
OF SKILLED PERSONNEL.
- FOR ANY ELECTRIC/ELECTRONIC OR MECHANIC TAM-
PERING OF THE MACHINE BY THE USER OR IN CASE
OF A NEGLIGENT USE OF THE MACHINE, THE MANU-
FACTURER IS RELIEVED FROM ANY RESPONSIBILITY
AND THE USER WILL BE THE ONLY ONE RESPONSIBLE
AGAINST THE COMPETENT AUTHORITIES FOR THE
ACCIDENT PREVENTION.
1.2 - REFERENCE NORMATIVE
- The machine and its safety components have been
manufactured in compliance with the directives indi-
cated in the declaration of conformity.

1.3 - DESCRIPTION OF THE SYMBOLS

Many accidents are caused by a poor knowledge of
and by a non compliance with the safety regulations
to put into practice during the functioning and main-
tenance works to be done on the machine.
In order to avoid any accidents, read understand
and follow all the warnings and cautions contained
in this booklet and those written on the plates located
on the machine.
To identify the safety messages included in this bo-
oklet, following symbols have been used:
DANGER
This symbol is used in the safety messages con-
tained in the booklet in case of potential danger
situations or possibility to cause serious injuries
or dead.
EN - 4
General specifi cations and warning
ATTENTION
This symbol is used in the safety messages of the
booklet for any danger situation that, if disregarded,
may cause small or moderate injuries or damages.
The message can be used also in case of danger si-
tuations that may cause damages to the machine.

IMPORTANT

This symbol is used in case of precautionary measu-
res to be taken in order to avoid any operation that
may reduce the life of the machine or for important
communication to the operator.
For clarity reasons, some illustrations of this booklet
show the machine without safety guards. DO NOT
USE THE MACHINE WITHOUT SAFETY GUARDS.

1.4 - MACHINE COMPOSITION

Manufacturer's machines are the results of a conside-
rable experience.
• Convection ovens can be single-chamber, double-
chamber or three-chambered ovens and are com-
posed of a duly insulated stainless steel outer shell,
a stainless steel conveyor belt with fi ne links and a
convection cooking system functioning by means of
resistances.
Hot air recirculation by a fan.
• The oven/s are supported by a bearing base.
DANGER
G45