STA-RITE SUPERMAX-VS2 Guide De L'installateur page 12

12
14. Press the Start/Stop button and ensure the LED is lit.
The pump is now on and will run the custom user-
programmed schedule.
Note: If the pump has been stopped via the Start/Stop
button, the pump will not run until the pump is turned
back on by the Start/Stop button. If the Start/Stop
LED is illuminated then the pump is on and will run
the programmed schedule.
Note: If a user wants to have a period of time during
the day when the pump is not running, any of the
SPEEDs can be programmed to 0 RPM. This will cause
the pump to remain stationary/paused throughout the
duration of that SPEED.
Speed Priorities (Non-External Control)
For schedule duration settings, SPEEDs are prioritized as
follows: SPEED 1 -> SPEED 2 -> SPEED 3. SPEED 1 is the
highest priority, while SPEED 3 is the lowest.
The drive will not allow a user to program a schedule
of more than 24 hours. When the 24th hour of duration
is programmed it will take time from the lower priority
speeds in order to add them to the SPEED currently
being adjusted.
Example:
Starting Schedule (Before Adjustment)
SPEED 1 duration = 20 hours
SPEED 2 duration = 2 hours
SPEED 3 duration = 2 hours
If the user reprograms SPEED 1 to run for 23 hours,
SPEED 2 (lower priority speed) will automatically
adjust to a 1 hour duration and SPEED 3 (lowest
priority speed) will adjust to a
End Schedule (After Adjustment)
SPEED 1 duration = 23 hours
SPEED 2 duration = 1 hour
SPEED 3 duration = 0 hours
Operating the Pump While Running
If power is connected to the pump motor, pressing any of the
following buttons referred to in this section could result in the motor starting. Failure to
recognize this could result in personal injury or damage to equipment.
Pressing the Display button will cycle through the current
parameters.
• Speed — current run speed
• Time — current time of day
• Duration — amount of time remaining at
0 hour duration.
the current run speed
• Watts — amount of watts currently
being consumed
Pressing any of the Speed Buttons ("1", "2", "3", "Quick
Clean") while the pump is running will act as temporary
override. It will run the speed and duration that is
programmed for that button. Once completed it will
default back to the appropriate point in the programmed
schedule.
Note: If you adjust the speeds of the schedule
while the pump is running, it will run the adjusted
speed for the rest of the current duration, but will
not save the adjustments. Exception: Speed and
Duration adjustments to QUICK CLEAN will always be
immediately saved.
Quick Clean
If running Quick Clean, pressing the "+" or "-" arrows
will change the speed accordingly. Pressing the Quick
Clean button again within 10 seconds of pressing the
"+" or "-" arrows will allow you to adjust the duration of
Quick Clean via the "+" and "-" arrows. These changes
will be saved immediately and are the new defaults for
Quick clean. Pressing the Quick Clean button again will
cycle through the two Quick Clean settings. The pump
will exit out of editing mode if no additional buttons are
pressed within 10 seconds.
If Quick Clean is running and you wish to stop the Quick
Clean prior to the duration being completed you can
press and hold the Quick Clean button for 3 seconds
and the pump will return to the appropriate point in the
programmed schedule.
Some speeds might cause resonance and noise coming from the pump
in specific installations.
This can be solved by slightly modifying the speed.