Publicité
Errata for the FT-1000MP Operating Manual
The following information outlines seme cor-
rections that are needed tc be made in the oper-
ating instructions for the FT-1 OOOM P manu al. Yeu
can keep this as a reference, or else make the
changes tc the appropria te sections of the manual
by marking in corrections, as needed. We apolo-
gize for this inconvenience, and appreciate your
patience and understanding.
PACKET jack pinout
The pin connection information for the rear-
panel PACKET jack is incorrect as it appears on
pages 4 and 53. The correct pin-out sequence is
shawn below:
PACKET
GND
DATA OUT
BUSY
as viewed from rear panel
Meter Tuning
The meter tuning description for CW operation
as printed on page 28 is incorrect. The correct
description is provided below:
ln CW mode, when yeu tune a signal near the
center of the receiver passband, the boundary
arrows light, and the upper signal strength seg-
ments increase as yeu slowly tune the VFO knob.
The idea is tc tune for maximum indication, and sc
that a lone center marker illuminates in the lower
tuning meter (the bondary arrows turn off when
the marker is centered). If yeu detune, the arrows
illuminate; indicating tc re-center the marker.
For RTTY and Packet, dual segments appear
(representing the mark and space tones), and in
this case optimum tuning is achieved when even
balance and maximum separation between the
dual segments occurs. The minimum separation
between the segment is proportional tc the mark
and space tone shift (170 Hz, 425 Hz or 850 Hz)
We will caver more about RTTY & Packet opera-
tion later.
Keyer Operation
Menu selection 7-0 as printed on page 38 and
90 is incorrect, and should read as follows:
lAMBIC 1 - iambic keyer with ACS disabled.
Weighting is user-selectable via menu selection
7-0
lAMBIC 2 - iambic keyer with ACS enabled.
Weighting is set via menu selection 7-0.
On page 61, right column, third paragraph,
change the ward Keyer 1 tc Keyer 2.
QSK 1 VOX operation
On page 39, right column, the second para-
graph concerning keyer delay should read:
For QSK (semi break-in) CW operation, the
switch-over time delay from Tx tc Rx can be ad-
justed from 0 seconds (semi break-in) tc 5.10
seconds (in 1 O-ms steps) using menu selection
7-5.
On page 18, right column, item (9) DLAY
should read:
This control sets the hang time of the VOX
circuit, between the moment yeu stop speaking,
and the automatic switch from transmit back tc
receive. Ad just this for smooth VOX sc the receiver
is only activated when yeu want tc listen.
YAESU
Pe1.formance without compromise.
111
Publicité
