EUROM Force 2501 Mode D'emploi page 54

Problem
No or fluctuating
pressure (from the
adjustable nozzle).
Device stops.
Blown fuse.
Device vibrates.
The device regularly
starts and stops by
itself.
54
Cause
The adjustable
nozzle is in the
wrong position.
Blown fuse.
Active thermal
safety.
Nozzle is partially
blocked.
Electrical
installation is to
light.
Air in the water
supply hose.
Problem with the
water supply.
The nozzle is
partially blocked.
The water inlet filter
is dirty.
There is a kink in
the hose.
Pump or jet lance
are leaking.
Solution
Move the
adjustable nozzle to
the front or rear
position.
Contact a EUROM
authorized
professional.
Allow to cool and
remove the cause of
overheating.
Clean the nozzle.
Connect to an
installation with a
higher amperage.
Do not use an
extension cable.
Allow it to escape
by running water
through the device
while it is switched
off.
Do not use an
excessively long or
thin hose (min.
1/2".)
Clean the nozzle.
Clean the water
filter.
Straighten the hose.
Have them repaired
or replaced.
Safety instruction
Make sure the
device is switched
off.
Do not use the
device.
Make sure the
device is off.
Do not use the
device while cooling
off.
Make sure the
device is off and
drained.
Make sure the
device is off when
switching to
another electrical
installation.
Make sure the
device is off when
removing the
extension cable.
Make sure the
device is off.
Make sure the
device is off and
drained when
changing a hose.
Make sure the
device is off and
drained.
Make sure the
device is off and
drained.
Make sure the
device is off.
Contact a EUROM
authorized
professional.