EUROM Force 2501 Mode D'emploi page 53

Clean the floor cleaner
1. Make sure the device is off.
2. Remove the water supply.
3. Remove the floor cleaner (Figure 25, pos. 1)
from the extension lance (Figure 5, pos. 1) by
turning it 90°.
4. Clean both nozzles (Figure 25, pos. 2) with
the cleaning pin (Figure 25, pos. 3).
5. Flush them thoroughly (against the direction
of the high-pressure jet).
Troubleshoot
CAUTION
Contact a EUROM authorized professional:
•
•
The following problems can occur:
Problem
The device does not
start.
Fluctuating
pressure.
in the event of regularly recurring errors;
if the errors are not solved.
Cause
Plug not in the
power outlet.
Power outlet not
working.
Extension cord
broken.
Pump is sucking in
air.
Valves are dirty,
worn or broken.
Pump seal work.
The nozzle is
partially blocked.
Figure 25
Solution
Plug the power plug
into the socket.
Use another power
outlet.
Contact a EUROM
authorized
professional.
Contact a EUROM
authorized
professional.
Contact a EUROM
authorized
professional.
Contact a EUROM
authorized
professional.
Clean the nozzle.
Safety instruction
Make sure the
device is off.
Make sure the
device is off.
Do not use the
device.
Do not use the
device.
Do not use the
device.
Do not use the
device.
Make sure the
device is off and
drained.
53