EUROM Force 2501 Mode D'emploi page 48

Change pressure
4. To change the pressure of the adjustable
nozzle (Figure 18, pos. 1):
•
Slide forward for a high pressure
(Figure 18, pos. 2);
•
Slide backward for a low pressure
(Figure 18, pos. 2).
Adjust amount of foam
1. If applicable, release the trigger
(Figure 7, pos. 2).
2. Lock the safety lock under the trigger
(Figure 7, pos. 1).
3. Rotate the head of the foam nozzle
(Figure 19, pos. 2) to change the amount of
foam:
•
for more foam turn it clockwise
(Figure 19, pos. 1).
•
for less foam turn it anti-clockwise
(Figure 19, pos. 3).
After operation
WARNING
If the device is off, left-over in the device can still be under high pressure.
CAUTION
•
•
•
1. Release the trigger (Figure 7, pos. 2).
2. Lock the safety lock under the trigger (Figure 7, pos. 1).
48
Do not use the power cable to unplug or carry the device.
Do not wind the power cable too tightly or in sharp angles.
Do not wrap the power cable around the device.
Figure 18
Figure 19