EUROM Force 2501 Mode D'emploi page 50

Maintenance
WARNING
Do not repair or modify to this device.
WARNING
Always remove the plug from the socket before you start maintenance!
Repairs and inspections must be carried out by a EUROM authorized professional. If the
device, electric cable and/or electric plug are damaged, they should be replaced by the
manufacturer or its service employee or persons with similar qualifications to prevent risks.
Perform the following maintenance tasks after every use:
•
Carefully remove dust, sand or other dirt from the connections (nozzles, floor cleaner
lance, jet gun, high-pressure hose and water inlet).
•
Remove the nozzle from the jet gun. Regularly clean the nozzle with the supplied pin.
Flush it thoroughly (against the direction of the high-pressure jet).
•
Remove the floor cleaner from the floor cleaner lance. Regularly clean the floor cleaner
with the supplied pin. Flush it thoroughly (against the direction of the high-pressure jet).
Perform the following maintenance tasks regularly:
•
Regularly Vaseline the O-rings of the connectors to prevent them from drying out.
•
Clean the water inlet filter.
Grease O-rings
1. Remove the accessories from the
(Figure 6, pos. 4, 5 or 6) jet gun.
2. Apply Vaseline to the O-ring
(Figure 20, pos. 1).
50
Figure 20