EUROM Force 2501 Mode D'emploi page 46

Operation
WARNING
Before operating, see section Safety.
WARNING
Operating the device more than 2 minutes without water leads to damage of
the high-pressure pump. If the appliance does not build up pressure within 2
minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting".
CAUTION
If the lever of the jet gun is released, the pressure switch turns off the pump
and the high-pressure jet stops. The pump switches on again when the lever is
pressed.
Lock and unlock the trigger
1. If applicable, release the trigger
(Figure 16, pos. 2).
2. Turn the trigger (Figure 16, pos. 1) lock.
Start
1. Make sure the ON(I)/OFF(0) switch is in the OFF(0) position (Figure 5, pos. 10).
2. Open the external water supply completely.
3. Unlock the safety lock under the trigger (Figure 7, pos. 1).
4. Squeeze the trigger (Figure 7, pos. 2) for several seconds to remove the air from the
hose.
5. Switch the device on (Figure 5, pos. 10).
Cleaning
WARNING
Be aware of the kickback when squeezing the trigger.
46
Figure 16