Publicité
Les langues disponibles
Les langues disponibles
Software operation
7.1.4
Centrifuging radius
7.2
Machine Menu
7.2.1
Audible signal
7.2.1.1
General
7.2.1.2
Setting an audible signal
24 / 32
If, in exceptional cases, the maximum load indicated on the bucket is
exceeded, the speed must also be reduced. The permissible speed can
be calculated using the following formula:
For example: Maximum speed 4000 RPM, maximum load 300 g, actual
load 350 g
Please contact the manufacturer if you are not sure.
The centrifuging radius must be entered in centimetres.
It is possible to enter values between 5 cm and 16 cm.
1.
Switch off the mains switch.
2.
Press and hold down the ▲
button simultaneously.
3.
Switch on the mains switch and release the buttons.
4.
Press the ▲
[RPM x 100] button repeatedly until the centrifuging
'rd' are displayed.
radius and
[t] buttons to set the desired centrifuging radius.
5.
Use the
[STOP] button to save the settings.
6.
Press the
The audible signal sounds:
■
after a problem occurs in the 2 s interval.
■
after completion of the centrifugation run and rotor standstill in the 30 s
interval.
Opening the lid or pressing any button stops the audible signal.
1.
Switch off the mains switch.
2.
Press and hold down the ▲
button simultaneously.
3.
Switch on the mains switch and release the buttons.
[RPM x 100] button repeatedly until 'BEL 1' or 'BEL 0' is
4.
Press the ▲
displayed.
5.
Set
'0' or '1 ' using the [t] buttons beneath the time indicator.
0 = audible signal disabled.
1 = audible signal enabled.
[STOP] button to save the settings.
6.
Press the
Rev.: 12 / 10.2023
[RPM x 100] button and the [PULSE]
[RPM x 100] button and the [PULSE]
AB2300en
Publicité
