Salicru SLC CUBE 3+ PS Mode D'emploi page 85

2. INFORMATION FOR SAFETY.
2.1. USING THIS MANUAL.
The purpose of the SLC CUBE3+ PS documentation is to pro-
•
vide information regarding safety and to give explanations
about the procedures for the installation and operating of the
equipment.
The generic documentation of the equipment is supplied in dig-
ital format in a Compact Disc (Pendrive) and it includes among
other documents the own user's manual of the system.
Together with this user's manual and included in the documen-
•
tation CD/Pendrive, it is supplied the EK266*08 document re-
garding to «Safety instructions».
Read this manual carefully before making the erection or com-
missioning, location change, setting or any king of handling in
the equipment.
Compliance as regards to «Safety instructions»
is mandatory, being the user the legal respon-
sible regarding to its observance and application. Read them
carefully and follow the stated steps in the established order.
The equipments are supplied duly labelled for the correct iden-
•
tification of each part, which together with the instructions de-
scribed in this user's manual allows making any operating of the
erection and commissioning, in an easy, ordered way, without
doubt.
Finally, once the equipment is installed and working, it is rec-
ommended to keep the documentation CD/Pendrive in a safe
place and with easy access, for future consults or doubts that
could arise.
When an equipment differs from the figures shown in section
•
4, there will be additional explanatory annexes if they were
needed. In general they will be given in hardcopy.
The following terms are used in the document to be referred to:
•
«SLC CUBE3+ PS, CUBE3+, equipment or unit».-
ˆ
Uninterruptible Power Supply.
Depending on the context of the sentence, it can be re-
ferred either to the own equipment or to the equipment
with batteries, although all is assembled in one cabinet or
metallic enclosure.
«Batteries or accumulators».- Group or set of elements
ˆ
that store the electron flow through electrochemical
means.
ˆ «T.S.S.».- Technical Service & Support.
ˆ «Client, installer, operator or user».- Both are
used, but it also includes the terms of fitter and/or
operator, who will make the corresponding actions,
being able to fall over this person the responsibility of
making the respective actions to act in the name or
behalf of the user.
In case of installing the equipment in IT neutral regime, the
•
switches and circuit breaker protections must break the NEU-
TRAL as well as the three phases .
USER'S MANUAL
Inside the battery cabinet there are accessible parts with
•
HAZARDOUS VOLTAGES, so electrical shock risk exists, there-
fore it is classified as RESTRICTED ACCESS AREA. This is why
the key of the battery cabinet will not be available to the OP-
ERATOR or END USER, unless he has been trained properly.
2.1.1. Conventions and used symbols.
Some symbols can be used and shown in the equipment, bat-
teries and/or in the context of the user's manual.
For more information, see section 1.1.1 from EK266*08 document
regarding to «Safety instructions».
SLC CUBE3+ PS UNINTERRUMPTIBLE POWER SOURCE
85