Hettich ROTOFIX 32 A Mode D'emploi page 65

Removing the bucket
6.4 Inserting and removing adapters
Inserting
the adapter
removing
Adapter with positioning pin
1
Fig. 18: Adapter with positioning
pin
1 Inserting
2 Positioning pin
3 Inserting
the groove
AB1206en
1
2
3
1. Check that the rotor is firmly seated.
2. Grease the trunnions (3).
3. Insert the bucket (1) into the rotor from above. The trunnions (3) must
be in the grooves (2).
4. Push the bucket (1) down as far as it will go.
Pull the bucket (1) vertically upwards out of the rotor.
1
2
Insert the adapter (1) vertically into the bucket (2) from above.
Remove the adapter (1) vertically upwards out of the bucket (2).
2
3
Insert the adapter (
The positioning pin (
Rev.: 17 / 01.2024
1
2
3
1
2
1 ) into the bucket
2 ) must be in the groove ( 3 ) of the bucket.
Operation
23 / 39